Olympus DS-4000 LCD displays "MEMORY ERROR" when switched on

Feb 22 2012

Support Center » Knowledgebase » Olympus DS-4000 LCD displays "MEMORY ERROR" when switched on

	Olympus DS-4000 LCD displays "MEMORY ERROR" when switched on

Solution If "MEMORY ERROR" is displayed on the LCD when your recorder is switched on, or if the recorder buttons and/or switch will not respond, it is likely due to a battery pack issue. Although rare, this problem is likely to happen on the DS-4000 when a NEW battery pack is being used. Battery packs included with the DS-4000 are rechargeable battery packs. The battery pack out of the box DOES NOT hold enough charge to power up the recorder through its initial start-up procedure.
1. Turn OFF the recorder and remove the battery pack and memory card for 10 seconds.
2. Install the memory card in the card slot.
3. Install new AAA batteries before you turn ON the DS-4000.
In rare occasions where these problems persist, recorder re-initialization to factory default or re-formatting of your memory card could be required to restore the recorder to a working order.

Your battery pack may also not be fully charged. All new battery packs must be fully charged from 2.5 to 3 hours before first time use. For the first week to 10 days of use, it is recommended to recharge the battery pack as often as possible. This will exercise it and improve its charge-hold capacity.

Article Details

Article ID:

Created On:

30 Dec 2006 07:05 AM